Desk setup ideas
Popular monitor setups people actually build
These are the desk layouts that come up again and again: a big main display with a portrait side screen, a sharp 4K center between two vertical monitors, a dashboard strip under an ultrawide. Each one is drawn to scale with an estimated desk span, and each opens in the builder so you can fit it to your own room before buying anything.
Start with the layout closest to how you work, check the desk span against the room you have, then open it in the builder to tune spacing, angles, and side-monitor orientation.
Easiest first ultrawide
34-inch ultrawide with a portrait 27
The cleanest way off a single 27-inch monitor. The 34-inch 3440x1440 panel carries your main work, and a 27-inch screen turned vertical handles chat, docs, and reference without taking much extra desk.
- Desk span
- ≈ 51.8 in
- Total pixels
- 8.6 MP
- Best for
- First ultrawide · coding · everyday work
Serious productivity
40-inch 5K2K with a reference screen
5120x2160 keeps a full 4K worth of vertical room and adds width for an editor beside a browser. The portrait 27 next to it is where the terminal, docs, or Slack live so the main canvas stays focused.
- Desk span
- ≈ 57.4 in
- Total pixels
- 14.7 MP
- Best for
- Developers · analysts · dense work
Immersive middle ground
45-inch OLED with a side monitor
The 45-inch OLED is the cinematic step between a 40-inch productivity panel and a full 49-inch super ultrawide. A portrait 27 on the side keeps reference material off the big curved canvas.
- Desk span
- ≈ 61.9 in
- Total pixels
- 8.6 MP
- Best for
- Gaming · creative work · wide desks
Dual-monitor replacement
49-inch super ultrawide command center
A 49-inch 32:9 panel is two 27-inch 1440p screens fused into one without the center seam. Add a portrait 27 and you have a real command center for an IDE, browser, logs, and chat at once.
- Desk span
- ≈ 67.8 in
- Total pixels
- 11.1 MP
- Best for
- Trading · monitoring · multi-window work
Classic three-screen desk
32-inch 4K flanked by two portrait 27s
A sharp 32-inch 4K in the center with two 27-inch monitors stood vertical on either side. It is the layout most people picture for a triple-monitor desk, and it stays readable because the sides are portrait.
- Desk span
- ≈ 63.1 in
- Total pixels
- 15.7 MP
- Best for
- Office work · support · dashboards
Add a control surface
Dashboard strip under a 5K2K ultrawide
A small portable screen tucked below the main ultrawide for stats, chat, music, or build status, plus a portrait 27 on the side. The little display keeps low-attention information off your primary work area.
- Desk span
- ≈ 57.4 in
- Total pixels
- 16.8 MP
- Best for
- Streamers · sim racing · busy desks
Command-center stack
Stacked ultrawides for a wraparound desk
A 45-inch OLED as the main canvas with a 34-inch ultrawide stacked above it and a portrait 27 to the side. It is a lot of desk, but it gives you separate zones for focus, monitoring, and reference.
- Desk span
- ≈ 61.9 in
- Total pixels
- 13.6 MP
- Best for
- Power users · multi-context work
How to read these layouts
The desk span is the edge-to-edge width of the screens plus a small comfort margin, so it is the number to check against your desk first. Side monitors are shown in portrait because that is how most people run a second screen next to a large main display: it keeps chat, docs, and reference readable without stealing width. None of these are fixed recipes. Open any one in the builder to change the desk width, swap a side screen, angle the panels, or drop a monitor entirely.